Tascam USB-US-144 MK2

Aux critiques
Cet article n'est pas disponible actuellement
  • 0020104985
  • 99,00 €

    compris TVA plus frais de port

    Non disponible actuellement

    The Tascam US-144MKII seamlessly continues the worldwide success of its predecessor US-144...plus

    Informations sur le produit "Tascam USB-US-144 MK2"

    The Tascam US-144MKII seamlessly continues the worldwide success of its predecessor US-144 offering better recording quality from a unit further reduced in size. Since it doesn’t require an additional power supply, this portable audio/MIDI interface is perfect for creating 4-channel recordings from analogue and digital sources with a laptop computer.

    XLR microphone inputs with switchable phantom power and high-quality preamps are the basis for good-sounding recordings, while input signals can be listened to by headphones with zero latency. Line-level and digital sources or an instrument can be connected as well. And there are separate level controls for the line and headphones outputs, a mono switch, MIDI input and MIDI output, as well as a coaxial SPDIF output.

    The US-144MKII supports sample rates up to 96 kHz at 24-bit resolution. While commercial audio CDs are produced at 44.1 kHz/16-bit, this interface offers you more than double the sample rate which means more detail for your recordings.

    Features

  • Provides four audio inputs and four audio outputs (two analogue, two digital) for a Windows or Macintosh computer
  • Two XLR mic inputs
  • Switchable phantom power (48 volt)
  • High-quality, low-noise mic preamps
  • Two analogue line inputs (one switchable to high impedance for use with guitars, basses, etc.)
  • Stereo digital audio input and output (input: SPDIF, output: selectable SPDIF or AES/EBU)
  • MIDI input, MIDI output
  • Up to 96-kHz/24-bit for high quality recordings
  • Zero-latency hardware monitoring with level control and mono switch
  • Separate controls for output level and headphones volume
  • USB 2.0 equipped (also supports USB 1.1)
  • USB-powered, no AC adapter required
  • Solid aluminum side panels
  • Cubase LE4 included
  • Technical Data

    Analogue audio inputs and outputs
    Mic input XLR, balanced
    Nominal input level –58 dBu (INPUT control set to MIC)
    –14 dBu (INPUT control set to LINE)
    Maximum input level +2 dBu (INPUT control set to LINE)
    Headroom 16 dB
    Input impedance 2.2 kOhm
    Line input 6.3-mm jack, unbalanced
    Nominal input level –40 dBu (INPUT control set to MIC)
    +4 dBu (INPUT control set to LINE)
    Maximum input level +20 dBu (INPUT control set to LINE)
    Headroom 16 dB
    Input impedance 15 kOhm
    Guitar input (LINE/GUITAR IN R, GUITAR position) 6.3-mm jack, unbalanced
    Nominal input level –51 dBu (INPUT control set to MIC)
    –7 dBu (INPUT control set to LINE)
    Maximum input level +9 dBV (INPUT control set to LINE)
    Headroom 16 dB
    Input impedance 1 MOhm
    Line output (LINE OUT) RCA, unbalanced
    Nominal output level –10 dBV
    Maximum output level +6 dBV
    Output impedance 200 Ohm
    Phones output (PHONES) 6.3-mm stereo jack
    Maximum output power 18 mW + 18 mW (32 Ohm)
    Digital audio input and output
    Digital input (DIGITAL IN) RCA (coaxial)
    Format IEC 60958-3 (SPDIF)
    Digital output (DIGITAL OUT) RCA (coaxial)
    Format IEC 60958-3 (SPDIF) or IEC 60958-4 (AES/EBU), selectable via the software control panel

    Other inputs and outputs
    MIDI IN and MIDI OUT 5-pin DIN connector (conform to MIDI specification)
    USB port USB series B connector (4-pin)
    Format USB 2.0 High speed (480 MHz)
    USB 2.0 Full speed (12 MHz, USB 1.1 equivalent)
    Audio performance
    Sampling rate 44.1 kHz / 48 kHz
    88.2 kHz / 96 kHz (USB 2.0, High-speed only)
    Bit depth 16/24 bit
    Frequency response (MIC IN to LINE OUT)
    44.1/48 kHz sampling rate 20 Hz – 20 kHz, +0.5 dB/–1 dB
    88.2/96 kHz sampling rate 20 Hz – 40 kHz, +0.5/–1.5 dB
    Signal-to-noise ratio (LINE IN to LINE OUT, INPUT control set to LINE, 20 kHz LPF)
    Through ADC and DAC 98 dB(A)
    Through direct monitor 107 dB(A)
    Total harmonic distortion (LINE IN to LINE OUT, INPUT control set to LINE, 1 kHz, +20 dBu input, 20 kHz LPF)
    Through ADC and DAC 0.0045%
    Through direct monitor 0.002%

    Host computer compatibility
    Windows
    Operating systems Windows XP 32 bit SP2/SP3
    Windows XP 64 bit SP2
    Windows Vista 32 bit SP2
    Windows Vista 64 bit SP2
    or later
    Computer Windows® compatible computer with a USB port (USB 2.0 is recommended)
    CPU/clock Pentium 4 1.4 GHz or faster
    AMD Athlon 1.4 GHz or faster
    (or equivalent processor)
    Memory 512 MB or more for Windows XP 32-bit and Windows Vista 32-bit
    1 GB or more for Windows XP 64-bit and Windows Vista 64-bit
    Macintosh
    Operating systems Mac OS X 10.4.11
    Mac OS X 10.5.6
    or later
    Computer Apple® Macintosh® series equipped with a USB port as standard equipment
    CPU/clock Power PC G4, 1 GHz or faster, or Intel processor
    Memory 512 MB or more

    Power supply and other specifications
    Power supply via USB (5 V, max. 500 mA)
    Operating temperature 5–35 °C
    Dimensions (L x W x H) 179 mm x 136 mm x 47 mm
    Weight 0.7 kg
    Included accessories USB cable, Cubase LE4
    Lire, écr. et débatt. des analyses...plus
    Evaluations (0)
    Il n'y a pas encore de critiques pour cet article Écrire une critique
    Écrire une critique
    Écrire une critique
    Les évaluations sont publiées après vérification.

    Les champs suivis d'un * sont des champs obligatoires.

    Veuillez saisir la série de nombres dans le champ de texte suivant.
    Derniers articles consultés